Subject: RE: VF 160 Date: Mon, 29 Nov 2004 11:28:54 -0800
>
>If you have VF160 version 1.10 and up, you can update software via onboard
>CD-R.
>
>Please find an attached software update file for VF160 V.2.03
>
>
>
>If the file is zipped, unzip it first, then simply
>burn it onto a blank CD ( making a data disk).
>
>Remove the CD from PC and load it to VF160.
>
>Power Off and wait for 10 seconds and Power On.
>
>VF160 automatically goes into system update mode by LCD displaying;
>
>VF160MV2.03-------------File name of the system update, you are upgrading 
>to
>V.2.03
>02/02/20 Ver1.10 Sure?---This is your current revision number, if you
>currently have version 1.10.
>
>The above example, you are upgrading from V.1.10 to V.2.03
>Press [ENTER/YES] to start upgrading or re-writing flush ROM inside the
>VF160.
>
>You should see "Loading" then "Writing" then VF160 reboots the system
>automatically.
>
>
>NOTE: If VF160 is stuck with "Writing" in the LCD display, DONOT POWER OFF.
>Wait for at least 3 minutes then Power Off.
>
>When you turn On the VF160 next time, VF160 should boot up with the 
>software version you just updated which is version 2.03.
>
>
>VF-160 re-enters to system update mode again by showing:
>
>VF160MV2.03. -------------File name of the system update, you are upgrading
>to V.2.03
>
>03/03/12 Ver2.03. Sure?---This is your current revision number.
>
>Since the software is already upgraded, the version number on the first 
>line
>and second line are same.
>
>Press [EXIT/NO] to exit from system update mode. VF160 ejects the diskette
>from the CD-1A.
>
>
>
>
>
>Best Regards,
>
>Matt Suzuki
>
>Fostex Product Support.